The new Waze Wiki, aka Wazeopedia, is now live at Wazeopedia.waze.com! While this legacy wiki will remain accessible for the time being, it is no longer updated by the community. For the most up-to-date guidance, please visit your local Wazeopedia.

Please do not make any more updates to these legacy wiki pages, all future updates should be made in your country's local Wazeopedia.

Clock over a larger globe

User:Qwaletee/Elevation

From waze
Jump to: navigation, search
Road elevation

Road Elevation is used to indicate the relative height of roads to one another, not the absolute height. The default is ground, but it can be set lower (negative number) or higher. It is usually only needs to be set where one road passes over another, though Waze may support different visuals in the future for various elevations.

When two segments overlap but do not actually connect in the real world, they must have different Elevation values. Otherwise, Waze may generate a Map Problem report. If two roads cross at grade but traffic does not pass from one to the other, set a junction anyway, with all turns disallowed. See the similar discussion on Railroads at the end of this section.

The visual representation of the relative Road Elevation is different when viewed in the Waze Map Editor (WME) and the Client application. Details of the visual representation can be found at the end of this section.

{{{text}}}

Crossed segment display and elevation in the client, livemap, and the editor:

1. The Client App displays segment elevation based on the road type only, meaning Freeways are always on top, Major Highways are next, followed by Minor Highways, Ramps next, Primary Streets below all those, and finally Streets are at the bottom. This is the same order seen when setting the road type in the editor.

2. The WME uses the Road Elevation setting to display the relative elevation of the road. It displays the road with the highest "elevation" number at the top of the visual stack and works its way down as would be expected.

Although the client application does not benefit from the Road Elevation setting, it is recommended to set the Road Elevation relative to the physical mapping in the real world to enable possible future Client application updates to show the same visual representation as the WME.

3. Elevation -5 is used for some non-drivable roads, to help ensure that the routing engine does not try to connect or route drivers from roads onto non-roads by mistake. It acts to prevent false system reporting that the roads should be connected. This is no longer true for railroads. At-grade railroad beds shoudl now be set to Elevation=Ground, and a no-turns junction made at railroad crossings.


See Bridges for more information on elevation.

See Locked Segments for information on road ranks.