Junctions and Roundabouts (Australia)

From waze
Jump to: navigation, search

Introduction

This forms part of Australian Editing Best Practice. Editors are encouraged to follow these guidelines.

Junctions

Junctions should generally be drawn as simply as possible. T-junctions and cross roads are usually best as single 2-way roads that are connected with a single node. Only when there are large turning lanes and restrictions should a more complicated layout be considered.

Junctions that have been split into 1-way roads just because there's some painted chevrons in the middle of the road are completely unnecessary, and should be removed where they can.

Ukjunction1.jpg Ukjunction2.jpg

Roundabouts

Roundabouts should also be drawn as simply as possible, with single 2-way segments for each connecting road. Pairs of 1-way entry and exit segments are not really necessary. If you have an opportunity to remove these when rebuilding a roundabout, please do so. They will look much better on the client.

Ukroundabout1.png Ukroundabout2.png Ukroundabout3.png

Steps for redoing a roundabout:

  • Delete roundabout and 1-way "V"s
  • Drag main 2-way segments to the centre
  • Draw new roundabout

Small and mini-roundabouts should be drawn as large as possible. Any with a radius much less than 10m will not be visible on the client, so aim to get them close to this size if you can.

Naming Roundabouts

To aid navigation instructions, roundabouts should typically remain unnamed - where the client comes across a segment with no name it will use the next named segment as the next named instruction whilst retaining any turn signals.

If the roundabout does have a proper, signposted name, then this can be labeled using a 'Junction/Intersection' type landmark that fills the centre of the roundabout.

Common Issues With Roundabouts

  • If a roundabout doesn't have a central node or === symbols around the edge, then it is not a proper roundabout. The client will give 'keep left' and 'keep right' instructions instead of 'take the nth exit'. These junctions need to be deleted and redrawn.
  • If two entry and exit segments share the same junction on the roundabout, the exit will not be counted when entering at that junction. Entry and exit segments should always be connected via separate junctions.
  • Sometimes the client will say "Take the 0th exit" for a roundabout. This is often caused by an invisible node on or within the junction, and can only be deleted via the old editor.

Special Roundabouts

Sometimes a roundabout will get modified to change its shape and function, such that it is no longer a simple a roundabout.

Hamburger.png

One such example is the "Hamburger Roundabout", where the main carriageway goes straight through the middle of the junction. This should be drawn as if the main road was an over pass, with short ramps connecting it to the roundabout. The example here is near M62 Junction 27 (Leeds).

Some roundabouts get modified so much that they can no longer be considered roundabouts at all. Here are some examples: