| The new Waze Wiki, aka Wazeopedia, is now live at Wazeopedia.waze.com! While this legacy wiki will remain accessible for the time being, it is no longer updated by the community. For the most up-to-date guidance, please visit your local Wazeopedia.
|This new page is currently undergoing modifications. The information presented should be considered a draft, not yet ready for use. This content is open to changes from anyone during construction. If you would like to make changes or have questions, please post a message in this forum.|
The primary purpose of the Waze map is to provide a framework to present a Wazer an optimum route from one place to another place. Various street segment properties and configurations are weighted differently by the routing server. When troubleshooting routing problems it is important to understand how various segment properties configurable by a map editor effect routes provided to Wazers.
Waze routing essentially calculates the least cost route between the origin and the destination. When the navigation type is set to fastest the cost is primarily based on the time the route is calculated to take. When the navigation type is set to shortest the cost is primarily based on the distance of the route. The cost is based on the properties of the road segments that make up the route and the speed data collected for each road segment. There are other considerations that may cause the cost to deviate from simply the fastest or shortest route. These considerations are typically applied to the routes in the form of penalties that increase the cost of route. For example, if avoid toll road is set in the client, then the cost of road segments marked as toll is greatly increased. Thus a segment in a route that is penalized causes the cost of the route to be higher. In this manner Waze avoids penalized routes.
Speed and Distance Data
Distance data is calculated based on the geometry of a segment. Thus the placement of the junction nodes at segment ends and the placement of geometry nodes within a segment change the length of a segment.
Waze retains speed data for each road segment as discussed regarding traffic data. Map editors do not control the speed data. With the exception of the default speed, the speed data is based on actual drives of Wazers. It is important for segments to be properly placed on the map in relation to the drives (as shown in the GPS layer) so that waze assigns the wazers drive speeds to the proper segment.
There are several options in the client application that effect how the cost of the route is calculated.
- Navigation type - Fastest causes the route cost to be based on speed data. Shortest causes the route cost to based on distance. Fastest is the default setting.
- Avoid toll road - Causes segments marked as toll to be highly penalized. This setting is off by default.
- Avoid freeways - Causes freeway segments to be penalized. This setting is off by default.
- Dirt roads - Causes dirt road segments to be penalized. This setting can be set to Allow, Don't Allow or Avoid long ones. Don't Allow is the default setting.
- Vehicle type - Causes segments with appropriate vehicle restrictions to be penalized. This setting can be set to Private or Taxi. Private is the default setting.
The properties of a road segment effect routing:
As mentioned above the default speed data is based on the road type. The road type also affects routing as follows:
- Freeway - Avoided when "Avoid freeways" is selected in the client application. When "Avoid freeways" is selected in the client application, a very high penalty is applied for each freeway segment included in the route.
- Dirt road / 4X4 Trail - Avoided based on the "Dirt roads" setting in the client application. When the client application is set to "Allow," no penalty is applied. When the client application is set to "Don't Allow," a significant penalty is applied to transition from another road type to dirt road segments and to transition from dirt road segments to another road type. When the client application is set to "Avoid long ones" the transition penalties are only applied to a series a segments over a set length on the order of 300m.
- Parking Lot Road - Waze is designed to avoid routing through a parking lot to reach another destination. A significant penalty is applied each time the route transitions from a segment of parking lot road type to a segment of a different type. This penalty is not applied to first transition from a parking lot road if the route starts on a parking lot road.
- Private Road - Waze is designed to avoid routing through private roads. A significant penalty is applied each time the route transitions from a segment of private road type to a segment of a different type in the same manner as with Parking Lot Roads. This penalty is not applied to the first transition from a private road if the route starts on a private road. These penalties apply to transitions from Parking Lot Roads to Private Roads and to transitions from Private Roads to Parking Lot Roads. Detailed examples of using this penalty is discussed in detail in Private Installations.
- Non-Drivable Road Types - Waze should not route on the non-drivable road types of Walking Trail, Pedestrian Boardwalk, Stairway, Railroad and Runway/Taxiway.
To find optimal routes over long distance for many users is processor resource intensive. To reduce the processor required so as to find a route in a reasonable amount of time the waze routing algorithm may sacrifice finding the absolute optimal route in favor a finding a route that is likely to optimal or at least likely to be close to an optimal route in a much faster time using much fewer processor resources. One method of doing this is to essentially penalize routes that include lower road types in the middle of long routes. This essentially assumes that major highways and freeways will be mostly used for long routes and that highways will be mostly used routes of moderate length. Street segments are penalized when more than about 10-15 km from the ends of the route. Primary street and Dirt Road / 4X4 segments are penalized when more than about 15-30 km from the ends of the route. Minor highway segments are penalized when more than about 100-160 km from the ends of the route. Major highway segments are penalized when more than about 200-320 km from the ends of the route. Ramps and Freeways are not penalized.
The effect of pruning is that for longer routes Waze will favor higher road types for longer routes. Roads that are intended to provide routes between distant points should have a road type higher than residential roads that merely provide access to local destinations.
- Toll Road - Routes over toll roads are penalized based on the navigation setting set in the client app. This allows the user to avoid roads marked with the toll road attribute. When "Avoid toll roads" is on, waze applies a significant penalty for each toll segment on the route. When "Avoid toll roads" is off, waze applies a very low penalty for each toll segment on the route, to choose the non-toll route when other cost factors are essentially equal.
Turn restrictions are indicated by the Junction Arrows at the ends of a road segment. If the Junction Arrow is green then waze routing from the segment to the next segment indicated by the arrow is allowed. If the Junction Arrow is red then waze should not route from the segment to the next segment indicated by the arrow. If there is a purple question mark at the end of the segment then the turn restrictions are soft and routes through from the segment to the next segment are penalized as described regarding Soft and Hard Turns.
Waze should not route through a partial restrictions, indicated by a yellow Junction Arrow, during the time that the restriction is in effect. Partial restrictions are discussed further below.
Partial Restrictions can be applied to turn restrictions and to segments. Restrictions can be set for specified days of the week, for specified times of the day, for specified date ranges and for specified vehicle types. Multiple restrictions may be set for each turn or segment. Waze should not route though a partial turn restriction during the designated time for the designated vehicle type. Waze should not use a partially restricted segment for routing during the designated time for the designated vehicle type.
From the routing point of view, the relevant time is the time that routing algorithm calculates that the turn will be made or the segment will be entered. Waze will route through a turn or segment with a partial restriction that expires while in route if Waze calculates that the route will reach the restriction after the restriction expires. Waze routing will not route through a turn or segment with a partial restriction that is not in effect when the route begins but the partial restriction begins before Waze calculates the route will reach the partially restricted turn or segment.
From the routing point of view, the relevant vehicle is the vehicle that is set in the client application. Thus, restrictions for "private vehicles" will be effective for the standard Waze user as "private" is the default vehicle type in the client.
- One Way - Waze should not route the wrong way on a one way segment.
- Unknown - Waze favors roads that have been reviewed and corrected by editors. This is done by applying a penalty for each unknown direction segment on a route.
Waze provides for various methods for entering real time road closures. Road segments can be closed by direction. For routine routes, Waze should not use a segment for routing in the direction of the closure. For long routes, Waze may not account for closures that are far away.
Waze realizes that some routes are undesirable even if faster or slower. To avoid such routes waze penalizes several road configurations.
- Multiple Segment U-turns - right-hand traffic jurisdictions or with two right turns in less than 15 meters (49.21 feet) in left-hand traffic jurisdictions. The specific details on configuration, and criteria for this penalty are documented in the Intersections page of the Junction Style Guide.
- Highway Off/On Routing - Detour Prevention Mechanisms.
- Small Detours - Waze avoids routes that make a right turn and a U-turn or continue straight, make a U-turn and turn right to avoid a left turn. Waze applies a small penalty to routes that pass through the same intersection more than once as is also mentioned in Detour Prevention Mechanisms.